Description
The brake kit Forward Joyride will guarantee you a stable, efficient and easy to maintain braking.here delivered in its version, C-JET the brake kit Forward Joyride J-kit will allow you to easily insert your hose in the internal passage of your frame or to easily adjust the length of your hose.Attention, this disc brake kit is delivered in C-JET version The hose is connected to the housing but not to the lever. An insert is pre-installed on the hose and an olive is pre-mounted in the lever. It will be necessary to connect the hose to the lever and to have the adequate tools for the assembly of this kit.IN DETAIL: This kit contains: Lever - caliper - hose - disc - screws - insert and olive Brake type: hydraulic disc brake Lever type: straight lever Caliper type: PM Brake pads type: Organic Brake fluid: Mineral Hose length: 1500mm Disc diameter: 140mm Number of pistons: 2 J-KIT BRAKE ASSEMBLY: - Position your brake lever on your handlebar. - Mount your brake caliper on the disc brake bracket. - Remove the black rubber plug from the end of the hose. - Remove the end caps from the end of the brake levers. - Slide the black rubber nut cover over the hose. - Do not remove the small cap on the end of the hose. - Insert the brake hose into the lever nut. - Making sure to hold the hose to the bottom of the lever nut, tighten the nut to compress the olive inside the lever. There is no need to overtighten, the thread of the nut should remain visible, it is then hidden by the nut cover that you slid on the hose before. - Now you can operate the brake to finalize its installation.